|
E clip for retaining the Wiper Motor Gear Wheel on its axle pin...
|
|
|
Price: £0.34
|
|
|
|
|
Grommet 3/4ins x 1/8ins for 1/2ins diameter hole to carry the Windscreen Washer Tubing or Bonnet Release Cable through the bulkhead or firewall.
...
|
|
|
Price: £0.89
|
|
|
|
|
Remote or Bracket mounted washer pump. 12V This pump produces three times the volume of the original OE pump. We have tested it!
No need to remo...
|
|
|
Price: £18.30
|
|
|
|
|
Black Plastic Remote or Bracket mounted washer pump. 12V
Alternative to WEP01 as seen in lower photograph.
Lighter than WEP01
Held together wit...
|
|
|
Price: £9.76
|
|
|
|
|
Tubing for inside the washer bottle. There is sufficient for both pieces supplied in this short length to be cut once as appropriate....
|
|
|
Price: £0.42
|
|
|
|
|
Washer nozzle for the centre of the Air Intake Grille.
This is not absolutely as original but it is the current one offered by the original manufactu...
|
|
|
Price: £7.51
|
|
|
|
|
Washer Bottle in the original style with the mould release lines down the sides just like the original. `Some aftermarket replacements have the mould ...
|
|
|
Price: £20.40
|
|
|
|
|
Washer in line valve to prevent drain back.
Suits 4mm Internal Diameter Tubing...
|
|
|
Price: £4.81
|
|
|
|
|
Clear unmarked PVC tubing that fits between the Windscreen Washer Jets and the reservoir bottle. 166 cms long.
Enough for the inside of the bottle...
|
|
|
Price: £2.58
|
|
|
|
|
Green tint PVC tubing that fits between the Windscreen Washer Jets and the reservoir bottle. 166 cms long. Similar to the original type.
Looks very...
|
|
|
Price: £5.76
|
|
|
|
|
These 14 inch refills are suitable for installation in original centre hinged Trico speedblade wiper blade frames or SOCTFL funded replicas. They are ...
|
|
|
Price: £14.28
|
|
|
|
|
Carbon Brush to fit Wiper Motor. Three pieces are required of which one may need a little alteration with a small knife.
The High cost is in part due...
|
|
|
Price: £10.93
|
|
|
|